Product Features
The APS sectionalizing enclosures incorporate knowledge from years of experience in metals, plastics and paint coatings such as: aluminum, HDPE polymers, powder paint, plating, and anodizing.
Key Features:

1. Channeled stiffener for added strength

2. Wind Latch

3. Offset slide hinges allow easy removal and installation

4. Nuts for bolt lifting point

5. Angle braces welded inside provide front panel stiffness to prevent bending when pressure is applied along the front

6. Channelized Edges provide consistent alignment even when the base surface is not uniform

7. Industry Standard for mounting all manufacturers elbow connectors, 15kV -38kV, 2, 3, or 4 point junctions

8. Grounding Point

Standards & Technical Specifications:
- Available for 15kV, 25kV and 35kV applications
- Durable finish TGIC polyester powder coating
- Standard paint color: Munsell 76Y3.29/1.5 dark green, with tan and gray available
- Secure fit around the cover opening to prevent wire intrusion
- Industry standard mounting hole pattern for junctions, 200 and 600 amp
- Lightweight aluminum body and cover assures easy handling and installation
- Cover and body edges reinforced with channelized construction for added strength
- Enclosure fabricated from .90” aluminum
- Large three–phase fabricated from 0.125” aluminum
- Offset slide hinges allow easy cover removal
- Handle design prevents installation of padlock unless penta head bolt is fully seated
- Blind threaded lifting provisions
- Handle and lock mechanism hardware are easily replaceable with cover open
- APS fiberglass ground sleeves are available for all sizes to provide additional termination height
- Meets ANSI C57.12.29 corrosion resistance standards to 3000+ hours salt spray
- Fault indicator provisions available upon request
- RUS Approved